₿ DLP Mining Dashboard Take Pic Show Pic 🔊 Beepbuild AA

Selected Read Select All Deselect All Check the units to update. Fan / Freq / Voltage / Restart / Unlock act on the checked units; Read loads the first checked.

Fan Auto % Set Fans

Freq MHz Set Freq

Voltage mV Set Voltage

Defaults Edit Defaults Edit each unit's freq/voltage, then “Save And Load Defaults” saves and applies them to all 17 at once.

Restart Restart Selected Bitaxe Unlock Locked Bitaxe Units Restart = clean re-apply on the checked units. Unlock Locked = finds every locked (red) unit and, for each: clears the lock, sets 600 MHz / 1150 mV, then full-resets it — ignores the checkboxes.

Diagnose Show Lock Details Clear Full status + lock diagnosis & corrective action for the first checked unit (read-only). If it’s locked, also pulls ~2 min of pre-lock CSV history around the onset from the Pi.

Applies to the checked units above within ~5s (relayed through the Pi), with a ✓/⚠ confirmation. ⚠ Freq/voltage changes can destabilize hashing — change in small steps, watch temps.

Pi ⏻ Shutdown Pi Cleanly powers off the monitoring Pi (password + confirm required). The dashboard stops updating until you re-power the Pi by hand.

Capture EN2 (live, all units) Clear

Pulls each Bitaxe's real extranonce2 dispatch history (last ~8s) live from the fleet via the Pi (~5–10s). Units still on the old firmware show “needs new firmware”.

Read Device ID (all units) Clear

Probes each Bitaxe's core voltage regulator (TPS546) over I2C and shows its device ID. A unit that returns “no response” has a wedged regulator and needs a physical power cycle. Units still on the old firmware show “needs new firmware”.

Enter a zeros value (e.g. 13.50). When a group’s best zeros for the current block exceeds its threshold, that miner’s value in the highest-zeros column (under the Block Win target) turns green. Highlighting resets on each new block. The ATB column is unaffected.

Best Zeros Nerds Best Zeros Mini3 Best Zeros Cluster17